1- Take
the head pin and place one bead on,then the charm then the
last bead.Cut off the extra wire from about one inch from
the last bead.Take your round nose pliers and form a loop
in the end.
2- Take the leather lace and weave though the chain,making
sure to keep it straight and the chain taunt.
3- Cut the lace one inch from the end.Glue down the ends to
the last bit of lace showing on the chain.This will hold the
leather in place.
4- Take a split ring add it to the middle of the chain on
the front.(opposite side of where you glued down the lace)
Now add your charm to the ring and close with the pliers.
5- Take another spit ring to the ends and add your clasp pieces
to both sides.
|